Note: I have all the arduinos connected through RS232 to the computer (not through the USB Port) ![]() The other two control the addition of solids with a dispenser (connected through rs485) and the net is measured from a load cell (analog value), also PID control.Īll of the arduinos are connected with a labview program that defines set points and flows, and show in the screen the state of everything. ![]() Another, is similar to the second but controls a pneumatic valve. Another controls the addition of a solvent, it uses a balance (through rs232) to read the net of the liquid and to control another peristaltic pump (through rs485), to dispense the right amount and at a specific rate (PID control) One of the arduinos controls PH, measure and control of two peristaltic pumps (through rs485), one for the addition of Base and other for the addition of Acid. I’ve made a protocol for them all to communicate with labview and it’s quite easy to do. In a complex system, that controls chemical reactions. You can leave a response, or trackback from your own site.Īctually I have 5 Arduino Mega 1280 conected with labview. ![]() You can follow any responses to this entry through the RSS 2.0 feed.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |